Last edited by Mezigrel
Tuesday, October 20, 2020 | History

2 edition of Infrared studies of adsorption on metal halides. found in the catalog.

Infrared studies of adsorption on metal halides.

Roger St.Clair Smart

Infrared studies of adsorption on metal halides.

by Roger St.Clair Smart

  • 227 Want to read
  • 14 Currently reading

Published by University of East Anglia in Norwich .
Written in English


Edition Notes

Thesis(Ph.D.) - University of East Anglia, School of Chemical Sciences, 1969.

ID Numbers
Open LibraryOL13844877M

The current trend in metal nitride ALD is to move away from metal halides and to use organometallic precursors instead. With that in mind, we have been investigating the surface chemistry of a series of tetraethylmethylamido precursors. ATR infrared adsorption spectra of a Si() surface after each half-cycle during ALD deposition at K. This text then examines the results from studies of the infrared and Raman spectra of N2O4 in the solid and liquid phases at low temperatures. Other chapters consider the infrared spectrum of a mixture of N2O3 and N2O4, which has been studied in the liquid phase from 2 to 25 µ and in the solid phase from 2 to 35 µ, both at low temperatures.

CO is a toxic gas discharged as a byproduct in tail gases from different industrial flue gases, which needs to be taken care of urgently. In this study, a CuCl/AC adsorbent was made by a facile route of physically mixing CuCl2 and Cu(HCOO)2 powder with activated carbon (AC), followed by heating at K under vacuum. The samples were characterized by X-ray powder diffraction (XRD), inductively. Adsorption of hydrogen halides on alkali halide surfaces as studied by infrared spectroscopy R. St. C. Smart and N. Sheppard, J. Chem. Soc. D, , DOI: /C

A much more widely used synthetic method entails the metathetical exchange reaction between alkali metal aryloxides and the metal halide. This procedure has been applied to the synthesis of lanthanide, actinide, and d-block metal aryloxides as well as derivatives of the main group metals (Eqs , , , , The adsorption of methanol on titanium(IV) oxide in the anatase crystalline modification was investigated by IR spectroscopy and thermal desorption. It was established that coordinationally bonded alcohol and two types of methoxides are formed on the surface of the titanium dioxide (anatase). The adsorption centers of the methanol were found.


Share this book
You might also like
New Zealands first war

New Zealands first war

North Beach Hope VI housing redevelopment

North Beach Hope VI housing redevelopment

Cost effective recreation management

Cost effective recreation management

Trends in spawning populations of Pacific anadromous salmonids

Trends in spawning populations of Pacific anadromous salmonids

Retracing the Butterfield Overland Trail through Arizona

Retracing the Butterfield Overland Trail through Arizona

Bostons hospitals, 1870-1930

Bostons hospitals, 1870-1930

Housing

Housing

VA health care

VA health care

The lord of the rings

The lord of the rings

The selected works of Sigurdur Helgason

The selected works of Sigurdur Helgason

Major systems acquisition reform

Major systems acquisition reform

East Anglia and the great Civil War.

East Anglia and the great Civil War.

Infrared studies of adsorption on metal halides by Roger St.Clair Smart Download PDF EPUB FB2

Traditional molecular sieves are generally oxides that inevitably show some absorption in the mid- and far-IR range due to the vibrations of metal–oxygen bonds, which are Infrared studies of adsorption on metal halides.

book for the in situ observation of the reactions in molecular sieves through IR techniques. In this study, a new metal halide In[Ba 3 Cl 3 F 6] has been synthesized.

It exhibits a quite transparent window from to 22. The problem of obtaining the infrared spectrum of a molecular monolayer adsorbed on a bulk metal is discussed.

The intensity of an infrared absorption band in radiation reflected from the surface is calculated for (a) various optical constants of the adsorbed layer and the metal, (b) various thicknesses of the adsorbed layer, (c) various angles of incidence, and (d) both states of polarization Cited by: The use of high surface area alkali halide films as adsorbents in infrared studies was first reported by Kozirovski & Folman (I).

These films have the advantages of good transmission over a very wide infrared frequency range and comparatively well-defined surface structures.

The high area of a sample is achieved by depositing. Matrix Isolation Infrared Studies of Magnesium Chloride and Magnesium Bromide. Applied Spectroscopy27 (4), DOI: / I.

Eliezer, A. Reger. Infrared spectra and geometry of group II metal dihalides. Coordination Chemistry Reviews9 (), DOI: /S(00)Cited by: Pergamon Press Ltd. Printed in Northern Ireland Infrared study of adsorption of water and aromatic compounds on alkali halides V.

F~RMV.R and J. RUSSELL Department of Spectrochemistry, The Macaulay Institute for Soil Research, Craigiebuckler, Aberdeen (Received 24 September ) Abstract--Grinding aromatic hydrocarbons and quinones containing three or more condensed rings with alkali halides leads to markedly increased water adsorption on the alkali halide Cited by: 8.

Also Davydov, in his book on 'Infrared Spec- troscopy of Adsorbed Species on the Surface of Transition Metal Oxides' (published in his En- glish edition inbut previously in Russian in ) [7] devoted a chapter on 'Application of Infrared Spectroscopy to Mechanistic Studies of Heterogeneous Catalytic Reactions' where he took into account nearly the same reactions.

Matrix‐Isolation Study of the Infrared and Ultraviolet Spectra of Several First‐Series Transition‐Metal Dichlorides. The Journal of Chemical Physics51 (9), Infrared studies of the surface acidity of oxides and zeolites using adsorbed probe molecules.

Metal Halides, Metal Oxides, and Metal Sulfides (Group VIII). NMR Studies in Adsorption and Heterogeneous Catalysis. Catalysis Reviews7 (2), DOI: / Infrared (IR) absorption spectra have been measured before and after the PP specimens were subjected to electrical stressing under an AC field of kV cm −1, and hours.

[The changes in the absorption peaks occur mainly at, and cm −1. 8 The difference between absorption peaks D after and D o before the specimen was subjected to electrical stressing is. Journal of Citromatograplty, I01 () c Elsevier Scientific Publishing Company.

Amsterdam -- Printed in The Netherlands CHROM. EVIDENCE OF INTERACTIONS OF ORGANIC SORBATES WITH TRAN- SITION METAL HALIDES IN GAS-SOLID CHROMATOGRAPHY USING THERMODYNAMICS AND INFRARED STUDIES EUGENE J.

McGONIGLEand ROBERT L. GROB. Infrared spectra of HCl adsorbed on high-area alkali-metal halides: dependence of the effective surface ionicities on the ionic radius ratio A. Hardin and N. Sheppard, J.

Chem. Soc., Dalton Trans. Infrared and laser Raman spectra of [Ni(II)(diars)2X]X, (X=Cl, Br and I) have been used as probes to determine the structures of chelated diarsine molecules. The far-infrared, approximately cm-1 (–30 μm), lying adjacent to the microwave region, has low energy and may be used for rotational spectroscopy.

The mid-infrared, approximately cm-1 (30– μm) may be used to study the fundamental vibrations and associated rotational-vibrational structure. The higher.

An infrared spectroscopic study of the adsorption of carbon monoxide on silica-supported copper particles. Applications of Surface Science6 (), chemical properties using the adsorption of simple molecules 26 Adsorption of ammonia 27 Lewis acid centres (coordinatively un-saturated metal cations at the surface) 28 Br0nsted acid centres 33 Adsorption of carbon monoxide 37 Spectral identification of carbonate carboxylate Compounds 38 Far-infrared spectra are reported for compounds of formula A3M2X9, with M = Cr, Mo; X = Cl, Br; A = univalent cations, for the region cm Assignments for metal-terminal halogen and metal-bridging halogen stretching vibrations in the binuclear anion are proposed.

Data on several related mono-nuclear hexahalo complexes are included for comparison. An explanation is offered for. The adsorption of HCl on the surfaces of a wide range of high-area alkali-metal halides gave broad HCl absorption bands caused by hydrogen bonding to the surface halide ions.

Infrared study of. Similar materials have been studied in recent years and they have been employed chiefly in adsorption process of metal halides from ethanol solution [15] [16] [17]. However, only a few studies. The infrared absorption by methane physically adsorbed on alkali halide films at−°C was measured during the whole course of the adsorption and desorption experiments.

The alkali halide films—NaCl, NaBr, NaJ, KCl, KBr, KJ—were prepared in the IR cell by condensation on KBr disks. All observed bands of the adsorbed molecules are shifted compared to the bands in the gas spectrum. Water adsorption on metal surfaces: A general picture from density functional theory studies Sheng Meng,1,2 E.

Wang,1 and Shiwu Gao2 1Institute of Physics, Chinese Academy of Sciences, P.O. BoxBeijingChina 2Department of Applied Physics, Chalmers University of Technology and Go ¨teborg University, SE 96 Goteborg, Sweden ~Received 3 October ; revised manuscript.

Work function changes due to the adsorption of halides on () surfaces of fcc metals (Ca, Sr, Ni, Pd, Pt, Cu, Ag, Au, Al and Pb) were studied using periodic density functional theory. The two mechanisms were found to be clearly independent of each other because of the opposite factors that lead to the work function decrease, and are therefore.Factor group analysis on the deformed pyrochlore-structure hydroxyl transition metal halides M2(OH)3X (M = Co, Fe and Mn; X = Cl, Br and I) with the crystal symmetry ≡ D3d5 of space group No.

for their infrared (IR) and Raman spectroscopic studies are, for the fist time to the best of our knowledge, reported. Through a standard factor group analysis, we predict that there are 17 IR.Single crystal -ray diffraction studies on CoCl(pyrazine) confirm far-i.r.

spectroscopic evidence that in MX(pyrazine)[M = Co or Ni; X = Cl, Br, or I] the halogen atoms occupy terminal positions whereas the pyrazine groups are bridging, forming a sheet structure containing six-co-ordinate cobalt atoms.